Repair broken eyelgalss frame? - eyeglass frame repair
My glasses metal frame is broken in the nose (which the ship separates into two halves). The breach occurred when the nasal riight curve fits to the main screen, right next to the lens.
A soldier of the previous repair "closed" so the screw can not I take the lens, so that the weld is released. I did not try "" a little superglue, but it is not expected. However, there was a "brand" and must not have been a better choice. Is there an adhesive cement / epoxy I use to get in touch (maybe 1-2 mm of contact is Avaialable) on both sides of the metal structure of a relatively "good" for the repair? Not sure of the material, but it is lightweight and can be aluminum or light.
I wear contacts, so that they are back and I spend wanrt $ $ $ for a new series because it is rarely used.
In addition, each would recommnedqations how to link to improve the best forces to also be useful.
I ask this question here because the review is a "restoration of metal"
Thank you for the yearVance
Wednesday, January 6, 2010
Eyeglass Frame Repair Repair Broken Eyelgalss Frame?
Subscribe to:
Post Comments (Atom)
3 comments:
It will look good, but you can try JB Weld It 2 compounds when they mix react.Use an ice lolly stick to mix to make a little from both sides. Use a rubber band to hold tight.In repairing a metal, I have a persistent connection, it will be difficult because the metal is follow the instructions. Grinding may also be able to see better when it heals. Good luck
I have been a few times. Most pictures are made of titanium. I tried to epoxides with a little luck, as strong as JB Weld. The welding is still the best option. When the screw was a soldier first, then either the goal is not removed, or the screw is not necessary for the removal of the lens. I think it's true. It might even be possible to recast the weld and get in on the Peices with at least heat.
HTH
When the pavement repairs will be enough, try this ------->
JB Weld is actually a very good choice if you insert the pictures. However, a simple "butt" common will not have much power and is in danger to fall apart at the most inopportune time.
Try to be a relatively large piece of metal small enough to fit into a scab, "to use the JB Weld. (Cut a fork low prices, for example). The eye position, so that the resin can and mix it on the butt joint , then the rest is to scab and without risk to the epoxy cures, everything stays in place by the resin and the crust, which has absorbed a lot of surface repair and increases the rigidity of the lateral shear of the joint.
Good Luck
Post a Comment